Readers are advised to proceed with the construction of the presented circuits only after understanding the concepts from the core. Not adhering to this can lead to failures and frustrations.

Search This Blog

Loading...

Sunday, April 22, 2012

Make this Amplifier Short/Overload Protection Circuit

While working with high power amplifier designs, two things become crucial, the protection of the amplifier and the protection of the speakers from an accidental over current influx.


Especially when the amplifier design involves costly mosfets, the design becomes specifically vulnerable to short circuits at the outputs.

A short circuit at the output may be caused due to mishandling or ignorance from the part of the user.

Whatever might be the reason, the end results in the destruction of the precious mosfets inside the amplifier box.

The above mishap can be prevented by adding a small circuit for detecting a short circuit conditions at the outputs of an amplifier.

The given amplifier short/overload protection circuit diagram, shows an inexpensive design using just a single transistor for implementing the intended feature.

Normally a low value resistor is usually employed at the output of mosfet amplifiers, the current developed across this resistor can be well exploited for tripping a relay in case it exceeds the safe maximum current value.

The current threshold across the above resistor is sensed by an LED inside an optocoupler, which lights up the moment a short or overload conditions is sensed.

This instantly triggers the opto transistor which in turn switches ON the transistor driver and the associated relay mechanism.

Since the relay coils support the amplifier connection with the speaker output, disconnects the amplifier from the output connection, preventing the amplifier devices from a possible damage.

The capacitor at the base of the transistor keeps the transistor switched for a few seconds so that the relay does not oscillate randomly.


7 comments:

  1. see, talk of ingenuity this is one of them, it obviously agreed with my slogan "simple and functional" keep it on.

    ReplyDelete
  2. HI
    this diagram seems not complete how does the relay power up?where is the source of its power?

    ReplyDelete
    Replies
    1. Hi,
      yes by mistake the positive connection is not shown in the diagram, a separate +12V should be connected to the link that connects the relay coil and the opto transistor.

      Delete
  3. have you built and tested this project/the project is impressive does this protection also include d.c currents against the speakers?

    ReplyDelete
    Replies
    1. not tested, but i am sure about it.

      yes it would also handle DC shorts across the speaker

      Delete

Readers are requested not to include external links while commenting. For consulting a diagram, upload it on Google Drive and provide the link here.